منبع تغذیه و رگولاتور 5 آمپر قابل تنظیم با امکان تغییر ولتاژ و جریان خروجی

توضیحات

Specification:

State: 100% new

Input voltage: 6-38V

Output Voltage: 1.25-36V (continuously adjustable)

Output current: adjustable, up to 5A.

Output Power: 75 W. Max

Operating temperature: -40 ~ + 85 ℃

Operating frequency: 180 Khz.

Conversion Efficiency: up to 95%.

Short circuit: Yes

Overheating protection: Yes

Backlink entry: No

Weight: ppro. 19g / 0.7 oz

This module is adjustable step-down module, the module can be adjusted above sinking blue adjustable resistance to change the output voltage. Input and output pressure of 1V, 0.8V minimum output voltage can be.
 indicated module above IN- (input negative), IN + (positive input), OUT- (output negative), OUT + (positive output) must then correct, otherwise may cause damage to the module.

 battery recharging methods:
1. Make sure you need to recharge battery float voltage and charge current, input voltage of the module;
2. Adjust the constant voltage potentiometer, the output voltage is regulated to about 5V.
3. 10A current with a multimeter measuring the output short-circuit current block, while adjusting the constant current potentiometer allows the output current reaches a predetermined charge current value;
4. turn lamp current default shipping charge is 0.1 times the charging current (current value).
5. Adjust the constant voltage potentiometer allows the output voltage reaches the float voltage;
6. connected to the battery, try charging.
(1,2,3,4,5 step for the module connected to the power supply input, output load is not connected to the battery.)

 LED constant current driver Usage:
1. Make sure you need to drive LED current and the maximum operating voltage;
2. Adjust the constant voltage potentiometer, the output voltage is regulated to about 5V.
3. 10A current with a multimeter measuring the output short-circuit current block, while adjusting the constant current potentiometer allows the output current reaches a predetermined LED working current;
4. Adjust the constant voltage potentiometer allows the output voltage reaches the LED maximum working voltage;
5. connected to the LED, test machine.
(1,2,3,4 take steps to block input power, output load is not connected LED